8.
Do not apply pressure to combs. Do not touch razor heads with hard objects as this may dent or damage
Do not use razor if combs are damaged or broken. Facial injury may occur.
Power Cord is not waterproof. Do not let cord get wet and do not immerse cord in water.
After Each Use
1Switch Razor OFF.
2Press the Razor Head Release Button located on side of Razor.
3 Flip open the Razor Head Assembly and clean the razor heads and hair chamber by running under hot water. Water from the tap should be on a hot setting BUT BE CAREFUL TO TEST WATER FIRST SO AS NOT TO BURN OR SCALD HANDS.
4Close the Razor Head Assembly and shake off excess water.
5Open Razor Head Assembly again and leave open to air dry.
9.
Replacing Lotion Cartridge
1Slide down latch and lift back cover off razor. Remove empty cartridge from razor and pull out the connector. Insert the connector into a new cartridge.The connector is secured when you hear it “click” into place.
2Rinse out razor cartridge compartment with hot water. Shake off excess water and slide new cartridge with connector into the Razor. Close back cover.
Every 2 Months: Razor Heads
For consistently close and comfortable shaves, razor heads should be cleaned in a degreasing liquid or alcohol and then lubricated.
1Turn razor OFF.
2Press the Razor Head Release Button located on right side of razor.
3Remove the Razor Head Assembly and clean the razor heads and hair chamber by running under hot water. Be sure water is not too hot so as to cause burns or scalding.
4While holding Razor Head Assembly in one hand, squeeze
5Remove one cutter/comb at a time, out of frame. IMPORTANT: Do NOT interchange the cutters and combs.They are a matched set and if interchanged may adversely affect shaving performance until cutters reseat themselves.Therefore, remove, clean and replace each set individually.