V940 OM.qxd 12/28/05 11:17 AM Page 11
DIRECTIONS FOR USE (cont’d)
Changing Scale Between (°F) and (°C):
The Thermometer can display temperature in either Fahrenheit or Centigrade. To change the scale, follow the instructions below:
1. Start with the thermometer turned off.
Fig. 7
2. Simultaneously, press and hold the Mode ( 
) and Memory ( 
) buttons for approximately 2 seconds. Release buttons after the beep. The display will first show the previously used scale. Press the Mode ( 
) button to switch to the alternate scale (Fig. 7).
3.When the “hourglass” symbol ( 
) disappears, the
thermometer is ready to measure by the selected measurement scale.
NOTE: If thermometer is turned off before a measurement is taken after the scale change, the scale will revert to the one last used.
Memory Mode:
When the unit is off, you can enter Memory Mode by pressing the Memory ( 
) button.
Press the Memory ( 
) button again to recall up to 10 past measurements (Fig. 8). The readout will indicate the temperature, elapsed time since the reading and measuring location.
Fig. 8 |
11