Fluke 65 specifications Replacement Parts Description, Fluke Part Number

Page 8

Model 65

Calibration Information

8.Press D to enter the high-temperature adjustment mode (display shows 2_H), as shown in Figure 2.

9.Press G. The default high-temperature appears on the UUT display.

10.Aim the UUT at the blackbody target; then use F or D to adjust the UUT reading down or up, respectively, to read 350 °C.

11.When you have set the UUT reading to 350 °C, press G. The UUT display flashes briefly, then returns to the calibration selection mode.

Note

If the high temperature you enter during calibration varies greatly from the measured temperature, the UUT display will flash Err after you press G. In this case, press G again to exit the error mode. Verify that the blackbody is working properly; then try the calibration again.

12.Press D to enter the end-of-calibration mode (display shows E), as shown in Figure 2. Press G to exit the calibration menu.

13.Test the UUT’s operation by running the performance tests given earlier under “Performance Tests”. If the UUT fails the performance tests, recalibrate the UUT and try the tests again. If the UUT continues to fail, return it to a Fluke Service Center for repair or replacement.

Replacement Parts

Table 3 shows the replacement parts available from Fluke for the Model 65 Infrared Thermometer.

Table 3. Replacement Parts

Description

Top case

Bottom case

Battery door

LCD lens

End cap

Keypad

Softcase

Holster

AAbattery, 1.5 V, carbon-zinc (2 required) AA battery, 1.5 V, alkaline (2 required)

Model 65 Infrared Thermometer Instruction Sheet

Americas (English, Spanish, French, Portuguese)

European I (English, French, German, Italian, Finnish, Dutch, )

European II (English, Norwegian, Spanish, Portuguese, Swedish, Danish)

Asian (English, Korean, Japanese, Simplified Chinese, Traditional Chinese, Thai)

Model 65 Infrared Thermometer Quick Reference Card (English only)

Fluke Part Number

803566

803509

803517

803558

803525

803541

670676

670612

650181

376756

801826

801842

801859

801834

802261

8

Image 8
Contents Introduction Contacting FlukeSafety Information Specifications Maintenance Replacing the BatteriesPerformance Tests Setting Up for Performance Tests and CalibrationRequired Equipment UUT Reading Limits1 Calibration AdjustmentsPerformance Test Values Temperature at 0.95 Emissivity Calibration Adjustments Fluke Part Number Replacement PartsReplacement Parts Description