Battery Installation, Instructions for USE

BATTERY INSTALLATION

NOTE: The word Lo by itself does not mean the battery is low and needs to be changed. It means the temperature being measured is out of the thermometer’s range.

	Replace the battery when the low battery
	warning symbol appears (See Fig. 1). If
	only the symbol appears, you may still	Figure 1
	use the thermometer but you will need to	Figure 1
	use the thermometer but you will need to

replace the battery soon. If the symbol
appears with the word Lo (See Fig. 2),
you must replace the battery to use the			Figure 2
thermometer.			Figure 2
1.	Slide the battery
	compartment lid off.
2.	Carefully release the battery
	by using a non-metal tool
3.	Insert one 3-volt CR-2032
	lithium battery with the the
	positive side (+) facing up.
4.	Replace the battery compartment	Figure 3
4.	Replace the battery compartment
	lid by sliding it forward.

INSTRUCTIONS FOR USE

Please do not use this ear thermometer when the ear canal is wet.

1. Press and realease the POWER/SCAN
1. Press and realease the POWER/SCAN
button. The system will start its self-
testing cycle (See Fig. 4).
2. Once the self-testing is completed			Figure 4


(approximately 1 second), the
thermometer will beep twice and the
thermometer will beep twice and the
display will show the last temperature
recorded. This indicates the thermometer
is ready to take a temperature (See Fig. 5).			Figure 5
is ready to take a temperature (See Fig. 5).

3.Press the POWER/SCAN button again and do not release it. The symbol will appear beneath the last reading (See Fig. 6). The word Lo may also appear indicating the temperature registering is lower than 93.2°F/34°C. NOTE: The word Lo does not mean the battery is low and needs to be changed unless the low battery icon appears with it (See Fig. 7). It means the temperature being measured is out of the thermometer’s range.

4.Keeping the POWER/SCAN button depressed, insert the probe into the ear canal. The probe must be inserted well into the ear to allow the probe tip to continuously scan the ear canal. This will ensure an accurate temperature measurement (See Fig. 8).

5.After one second you will hear a beep indicating the reading is complete. Remove the thermometer from the ear and release the POWER/SCAN button to get the temperature reading.

6.A smiling face will appear indicating a temperature reading lower

than 100.4°F/38°C. A frowning face accompanied by one long and two short beeps, will indicate a temperature of 100.4°F/38°C or higher (See Figs. 9 and 10).

7.To change the reading from Celsius to Fahrenheit, press the POWER/SCAN button without releasing it, then press the blue M button on the underside of

Figure 6

Figure 7

Figure 8

Figure 9

Figure 10