Warning Messages
When display reads “LO BAT”, replace batteries.
Check Probe
“CHECK PROBE” indicates a probe error and is shown with a diagnostic code:
Diagnostic | Problem | Solution | |
Code |
|
| |
No | Probe cord is not connected | Verify cord connection is secure | |
to the thermometer. | or reconnect cord. | ||
| |||
|
|
| |
| Probe cord is not functioning | Check the wire and connection | |
| properly. Cord may have | ||
SC | for damage or excessive heat. | ||
been damaged or exposed to | |||
| extreme heat. | Replace cord. | |
|
|
Troubleshooting
Problem | Possible Solution | |
Inaccurate | • Use standard alkaline batteries. Do | |
not use heavy duty or rechargeable | ||
temperature | ||
batteries. | ||
| ||
|
| |
Check Probe | • Review Warning Messages (page 7) | |
Display screen | • Check that the batteries are installed | |
correctly. Batteries may need to be | ||
not working | ||
replaced. | ||
|
If your AcuRite product does not operate properly after trying the troubleshooting steps, visit www.AcuRite.com or call (877)
Care & Maintenance
Store in a dry location at room temperature. Clean thermometer with a soft, damp cloth. Temperature probe should be wiped clean with warm water immediately after direct contact with foods.
DO NOT place display unit on or near hot surfaces. DO NOT heat beyond thermometer’s temperature capacity. DO NOT use in oven. DO NOT wash in dishwasher. DO NOT immerse in water or use caustic cleaners or abrasives. DO NOT allow any part of the temperature probe or probe wire to come into direct contact with flames or
7