CARE AND CLEANING
1.The Remote Fever Monitor is a delicate electronic device. To insure proper functioning, do not immerse either unit in water and avoid dropping them.
2.Clean both units with a soft cloth moistened with either water or alcohol. Never use an abrasive.
3.Keep out of the reach of children and in the storage case when not in use. The optimal storage temperature is between
4.Do not disassemble the thermometer.
If you believe your Remote Fever Monitor is not operating properly, please check the batteries first. If it still does not operate normally, or you are having other technical problems, please contact:
Unisar Inc.
15 West 36th Street
New York, NY 10018
Tel.
10
TROUBLESHOOTING
Poor Reception
Cause: Child’s Thermometer is not sending a signal or the distance between both units is beyond the specified range for over 40 seconds.
Effect: Parents’ Unit will beep 3 times at 10 second intervals and the receiving symbol will disappear and SCAN will appear.
Solution: Check the position of the thermometer and/or move back into the transmission range.
Low Battery
Cause: Battery power is too low to operate the unit.
Effect: Parents’ Unit will beep every 5 minutes and the low battery symbol will appear.
Solution: Change the battery in whichever unit is causing the problem or in both units.
Temperature Too Low
Cause: Thermometer lost contact with baby’s skin or the baby’s temperature is too low.
Effect: The Parents’ Unit will beep for 10 sec- onds.
Solution: Check your child and the position of the thermometer immediately.
11