OPERATING INSTRUCTIONS
1.Always wear eye protection. Wear ANSI approved safety impact eye glasses when using this product.
2.Make sure the location in which you intend to use the Microscope is well lit.
3.Thoroughly clean and dry the Slide (7). (See Assy. Diagram.)
4.If necessary, section the specimen from 0.1 to 0.5mm thickness. Then, carefully position the specimen in the middle of the Slide (7). (See Assy. Diagram.)
5.Center the Slide (7) on the Specimen Stage (8), and hold the Slide in place using the Clip (6). (See Assy. Diagram.)
6.Turn the Turret (4) to align the 8X Objective Lens (5) directly over the specimen to be observed. For greater magnification of the specimen, align the 20X Objec- tive Lens over the specimen. (See Assy. Diagram.)
7.While viewing into the Drawtube & Zoom Eyepiece (1), slowly turn the mecha- nism clockwise or counterclockwise to bring the specimen image into focus.
(See Assy. Diagram.)
8.When finished viewing the specimen, move the Clip (6) off the Slide (7). Re- move the Slide from the Microscope. Properly dispose of or store the specimen. Then, thoroughly clean and dry the Slide. (See Assy. Diagram.)
9.Make sure to store the Microscope in a clean, dry, safe location out of reach of unauthorized people.
INSPECTION, MAINTENANCE, AND CLEANING
1.Before each use, inspect the general condition of the Microscope. Check for cracked, worn or damaged parts, and any other condition that may affect the tool’s safe operation. If a problem occurs, have the problem corrected before further use.
Do not use damaged equipment.
2.To clean, use a damp cloth and a mild detergent. Then dry. Do not use sol- vents as damage to the Microscope will occur. Do not immerse the Micro- scope in any liquid.
3.When storing, keep the Microscope in a clean, dry, safe location out of reach of children.
4.
CAUTION! All maintenance, service, and repairs not discussed in this manual should only be performed by a qualified service technician.
SKU 54949 For technical questions, please call