Installation
Locating the Elevator (Fig. 1)
1.Provide sufficient clearance in front of the elevator to change drums.
2.The ceiling must be at least 6 ft. (1.8 m) high for the elevator to be fully raised.
3.Be sure the air supply lines to the pump and elevator and the fluid outlet line from the pump can be brought to the site. Use several feet of hose between the pump and its supply lines to allow the pump to be raised and lowered.
Installing the Elevator (Fig. 1)
1.Use 3/8 in. size bolts (A) which are long enough to firmly secure the elevator base (110) to the con- crete floor. Use shims as necessary to level the base. Ensure that the elevator tube is in a true vertical position.
2.Position a 120 lb lubricant drum so that it is touch- ing the elevator base (110).
3.Loosen the screws (202) and nuts (203) on the bracket (204). Position the drum cover (207) squarely on the drum bead. Lightly tighten the screws and nuts.
Mounting the Pump
1.Mount a
2.Refer to your separate pump instruction manual for further information on system accessories and installation.
114
202,
203
204
Raised
71in.
(1803 mm)
111
Lowered
41.75in. (1060 mm)
0.25in. (6 mm)
110
A
Fig. 1
207
06543b
306522 3