GN Netcom 9000MWD manual Message Waiting Lamp

Page 21

Message Waiting Lamp

The 9000MWD supports a low-voltage LED message waiting lamp or 90VDC neon.

To turn ON, slide the switch to the “LED” or “NEON” position. The switch is located underneath the overlay and faceplate on the top of the base.

Note: The 9000MWD is factory preset to the “Neon” setting.

*NOTE: Voice Mail will ONLY operate if you subscribe to your local telephone company voice mail service and/or if your

!PBX telephone system is equipped with this technology. These telephone features will not work unless you are a subscriber.

20

Image 21
Contents Marquis 9000MWD Single Line Cordless Hotel Telephone Page Page Important Safety Instructions Canadian Emissions Compliance FCC Part 15 ComplianceDOC Notice and Load Number Statement Notification to the Telephone Company Consumer Information Page Page TOP View Base Unit TOP View of Handset Handset Unit TOP Side Left Side Modem, fax or answering device Parts Check List Wall Mounting Your Telephone Power Adapter Phone Connection Power Adapter Line ConnectionRemoving the Handset Battery and Battery Cover Install the Handset BatteryMessage Waiting Lamp Step Procedure Guest Service Keys Speed Dial MemoryProgramming The TouchLiteTM TouchLiteTM FeatureProgramming a Pause Into Memory Programming a Flash Into MemoryPlacing a Call Using The Handset Base Unit Dialing Placing a Call Using The Base UnitLocating The Handset Technology Feature Frequency Range LimitationUsing The Speakerphone Volume Control Using The Handset Volume ControlLine Status Indicators Handset Unit Line Status Indicators Base UnitUsing The Data Port Using The Mute Feature Using The Hold Feature on HandsetRedial On Handset Page Statement of Limited Warranty To Place An Order Spare Parts List