INSTALLATION INSTRUCTIONS
INSTALLATION
TO TELEPHONE | REAR OF THE | HANDSET |
| ||
WALL JACK | TELEPHONE BASE |
|
STRAIGHT TELEPHONE | COILED HANDSET CORD |
| |
CORD |
|
To Telephone Jack |
|
1.Insert the modular plugs of the COILED HANDSET CORD into the jack of the TELEPHONE HANDSET and into the jack on the left side of the TELEPHONE BASE.
2.Insert the modular plugs of the STRAIGHT TELEPHONE CORD into the modular jack at the REAR of the TELEPHONE BASE and into the TELEPHONE WALL JACK (either end can be plugged in).
RINGER SETTING
This switch is located on the rear of the set. Select the desired function of the ringer. ON - Normal setting of rings on incoming calls.
OFF - No rings on incoming calls.
NOTE: If your RINGER switch is in OFF position, only THIS phone will not ring, other phones in your home on the same line will ring.
NOTE: Even if your RINGER switch is in OFF position, the indicator lamp will flash when there is an incoming call.
TONE/PULSE SWITCH
Select the type of dialing that you desire or that your telephone system requires. TONE - The phone will operate using tone dialing. (If your phone doesn’t dial out,
switch to PULSE.)
PULSE - The phone will dial using rotary pulse dialing.
NOTE: Even when your phone is set to pulse service, this phone can be switched to temporary tone dialing for access to services that require tone signaling like
computer systems. Just press the 
button after dialing in pulse and your buttons can now be used for tone signaling for this call only.
5IB-PH417-WM-E-022804