Cortelco 2203 Pausebutton, Message Waiting Lamp, Ry/B, Handsfreebutton, Speakervolume, Mutebutton

To Dial A Phone Number In Memory

1. Lift the handset and wait for a dial tone.

2. To dial an auto memory button (located on top of base) - Press the desired auto memory button.

3. The number will be dialed automatically.

PAUSEBUTTON

The PAUSE button allows you to insert a 3.6-second pause in the dialing sequence. This is particularly useful if you are connected to a PABX system where you must dial an access code (usually the number 9) to obtain an outside line. It can also be used when storing numbers in memory locations to insert a delay in the dialing sequence.

MESSAGE WAITING LAMP

The Message Waiting Lamp will light when a message is waiting at a properly equipped PABX or telephone central office. This switch located under plastic memory index cover allows the phone to be configured for 90V message waiting on T/R (tip/ring, the red/green wires) or Y/B (the yellow/black wires).

T/RY/B

If this switch is in T/R Position then the message waiting lamp also serves as visual ring indicator.

HANDSFREEBUTTON

The Handsfree button (HF) is used to go off-hook without lifting the handset.

SPEAKERVOLUME

Use the handsfree Speaker Volume slide control located on the right side of the phone base to change volume control handsfree. This increased volume should allow persons with hearing impairments to carry on normal conversations by adjusting the receive volume to its proper level.

MUTEBUTTON

Press MUTE to speak without the person on the phone hearing your conversation. The MUTE Indicator will light up and remain lighted until you resume your conversation. To resume your conversation, press MUTE. The MUTE indicator will go out and your call can continue.

9