INSTALLINGYOUR TELEPHONE
Write or type correct telephone number on number card and fit into finger wheel, aligning notch in number card midway in the space between the "0" and the "1" hole of the finger wheel.
Position the finger wheel gently under the finger stop. Align the "0" or "Operator" finger hole at the "9" position on the number dial. Let the finger wheel drop into position. Now rotate finger wheel counterclockwise until it clicks into place.
BEFORE USING YOUR TELEPHONE
ThistelephoneincludesaHandsetwithReceiverVolumeControl that complies with FCC Part 68 requirements mandated by the Hearing Aid Compatibility Act of 1988.
TheVolumeControlisasmallrotaryknobthatprotrudesfromthe inside of the Handset handle. The rotary knob may be conveniently operated with the thumb, index, or middle finger while holding the handset.
Rotating the knob toward the Receiver (upper) end of the Handset will increase the loudness from the Receiver.
Rotating the knob toward the Microphone (lower) end of the Handset will decrease the loudness from the Receiver.
The Volume Control will not disable the Receiver. The minimum loudness setting of the Volume control will usually produce a comfortable listening level for persons with no hearing impairment.
1.Set the ringer volume control. If the control is set to OFF, you will not hear the ringer when someone calls you.
2.If your telephone has a
•If you have pulse service, set the
•If you set the switch for TONE service, you must have TONE service or you cannot dial.
•If you set the switch for PULSE service and you have TONE service, you can dial numbers, but you cannot use distant services, such as
•If you have PULSE service and your telephone has