k. Enter the number of 3 second pauses to be inserted between
dialing the voice mail number and the PIN. For example, if you enter 2 here, the phone will pause 6 seconds.
l. Press DIAL/OK.
m. Lift the handset to end programming.
6.Set SDT - The 1220 can respond to Stutter Dial Tone Message Waiting. If this is set to ON, the phone will go off hook briefly after every call to check the dial tone. If it is stuttered, the message lamp will be lit. To select this feature, press DIAL/OK and then use or to toggle between OFF and ON. Press DIAL/OK to confirm.
7.Hold Mode - The 1220 has two hold modes: NORMAL and PBX. In Normal mode, the HOLD button will place the phone on local hold. This call can be retrieved from any phone connected to the line. In PBX mode, the HOLD button can be programmed to dial a code to place the call on PBX hold. Please note there is no hold indication in PBX mode. To select this feature, press DIAL/OK and then use or to toggle between NORMAL and PBX. Press DIAL/OK to confirm.
8.Select Line 1/2 - This selects the default line when the phone goes off hook.
b.Press or to select
c.Press DIAL/OK to confirm.
9.Set Access Code - This is a number that is dialed to access an outside line when the phone is used behind a PBX.
a.Press DIAL/OK.
b.Dial the access code (up to 4 digits).
c.Press DIAL/OK to confirm.
d.Press or to continue with programming.
128