may cause harmful interference to radio communications. However, there is not a guarantee that |
| LIQUID CLEANER OR AEROSOL CLEANERS. USE A DAMP CLOTH FOR CLEANING. | |
interference will not occur in a particular installation. If this equipment does cause harmful interfer- | 4. | DO NOT USE THIS PRODUCT NEAR WATER FOR EXAMPLE NEAR A BATHTUB, WASH | |
ence to radio or television reception, which can be determined by turning the equipment off and on, |
| BOWL, KITCHEN SINK OR LAUNDRY TUB, IN A WET BASEMENT, OR NEAR A SWIMMING | |
the user is encouraged to try to correct the interference by one or more of the following measures: - |
| POOL. | |
Move the telephone away from the receiver. | 5. | DO NOT PLACE THIS PRODUCT ON AN UNSTABLE CART, STAND OR TABLE. THE PROD- | |
cian for help. Any changes made by the user not approved by the manufacturer can void the user's | |||
| UCT MAY FALL, CAUSING SERIOUS DAMAGE TO THE PRODUCT. | ||
authority to operate the telephone. |
| ||
6. | SLOTS AND OPENINGS IN THE CABINET AND THE BACK OF BOTTOM ARE PROVIDED | ||
| |||
INDUSTRY OF CANADA REQUIREMENTS |
| FOR VENTILATION, TO PROTECT IT FROM OVERHEATING, THESE OPENINGS MUST | |
| NOT BE BLOCKED OR COVERED. THE OPENINGS SHOULD NEVER BE BLOCKED BY | ||
NOTICE: The Industry Canada label identifies certified equipment. This certification means that the |
| PLACING THE PRODUCT ON THE BED, SOFA, RUG OR ANY OTHER SIMILAR SURFACE. | |
equipment meets certain telecommunications network protective operational and safety requirements |
| ||
| THIS PRODUCT SHOULD NEVER BE PLACED NEAR OR OVER A RADIATOR OR HEAT | ||
as prescribed in the appropriate Terminal Equipment Technical Requirements documents. The |
| ||
| REGISTER. THIS PRODUCT SHOULD NOT BE PLACED IN A | ||
department does not guarantee the equipment will operate to the users satisfaction. |
| ||
| UNLESS PROPER VENTILATION IS PROVIDED. | ||
Before installing this equipment, users should ensure that it is permissible to be connected to the |
| ||
7. | NEVER PUSH OBJECTS OF ANY KIND INTO THIS PRODUCT THROUGH CABINET SLOTS | ||
facilities of the local telecommunications company. The equipment must also be installed using an | |||
| AS THEY MAY TOUCH DANGEROUS VOLTAGE POINTS OR SHORT OUT PARTS THAT | ||
acceptable method of connection. |
| ||
| COULD RESULT IN A RISK OF FIRE OR ELECTRIC SHOCK. NEVER SPILL LIQUID OF ANY | ||
The customer should be aware that compliance with the above conditions may not prevent degrada- |
| ||
| KIND ON THE PRODUCT. | ||
tion of service in some situations. | 8. TO REDUCE THE RISK OF ELECTRIC SHOCK DO NOT DISASSEMBLE THIS PRODUCT | ||
Repairs to certified equipment should be coordinated by a representative designated by the supplier. |
| BUT TAKE IT TO A QUALIFIED SERVICEMEN WHEN SOME SERVICE OR REPAIR WORK | |
Any repairs or alterations made by the user to this equipment, or equipment malfunctions, may give |
| IS REQUIRED. OPENING OR REMOVING COVERS MAY EXPOSE YOU TO DANGEROUS | |
the telecommunications company cause to request the user to disconnect the equipment. |
| VOLTAGES OR OTHER RISKS. INCORRECT REASSEMBLE CAN CAUSE ELECTRIC | |
Users should ensure for their own protection that the electrical ground connections of the power utili- |
| SHOCK WHEN THE APPLIANCE IS SUBSEQUENTLY USED. | |
ty, telephone lines, and internal metallic water pipe systems, if present, are connected together. This | 9. | UNPLUG THIS PRODUCT FROM THE WALL OUTLET AND REFER SERVICING TO QUALI- | |
precaustion may be particularly important in rural areas. |
| FIED SERVICE PERSONNEL UNDER THE FOLLOWING CONDITIONS. | |
Caution: Users should not attempt to make such connections themselves, but should contact the |
| · WHEN THE POWER SUPPLY CORD OR PLUG IS DAMAGED OR FRAYED | |
appropriate electric inspection authority or electrician, as appropriate. |
| · IF LIQUID HAS BEEN SPILLED INTO THE PRODUCT. | |
The Ringer Equivalence Number (REN) of this device is Z. |
| ||
| · IF THE PRODUCT HAS BEEN EXPOSED TO RAIN OR WATER. | ||
Notice: The Ringer Equivalence Number (REN) assigned to each terminal device provides an indica- |
| ||
| · IF THE PRODUCT DOES NOT OPERATE NORMALLY BY FOLLOWING THE OPERATING | ||
tion of the maximum number of terminals allowed to be connected to a telephone interface. The ter- |
| ||
| INSTRUCTIONS. ADJUST ONLY THOSE CONTROLS THAT ARE COVERED BY THE | ||
mination on an interface may consist of any combination of devices subject only to the requirement |
| ||
| OPERATING INSTRUCTIONS BECAUSE IMPROPER ADJUSTMENT OF OTHER CON- | ||
that the sum of the Ringer Equivalence Numbers of all the devices does not exceed 5. This tele- |
| ||
| TROLS MAY RESULT IN DAMAGE AND WILL OFTEN REQUIRE EXTENSIVE WORK BY A | ||
phone connects to the telephone network under the connecting arrangement code CA11A. |
| ||
| QUALIFIED TECHNICIAN TO RESTORE THE PRODUCT TO NORMAL OPERATION. | ||
|
| ||
IMPORTANT SAFETY INSTRUCTIONS |
| · IF THE PRODUCT HAS BEEN DROPPED OR THE CABINET HAS BEEN DAMAGED. | |
| · IF THE PRODUCT EXHIBIT A DISTINCT CHANGE IN PERFORMANCE. | ||
WHEN USING YOUR TELEPHONE EQUIPMENT, BASIC SAFETY PRECAUTIONS SHOULD |
| ||
10. | AVOID USING A TELEPHONE (OTHER THAN A CORDLESS TYPE) DURING AN ELECTRI- | ||
ALWAYS BE FOLLOWED TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK AND INJURY TO | |||
PERSONS. INCLUDING THE FOLLOWING: |
| CAL STORM. THERE MAY BE A REMOTE RISK OF ELECTRIC SHOCK FROM LIGHTING. | |
1. READ AND UNDERSTAND ALL INSTRUCTIONS. | 11. | DO NOT USE THE TELEPHONE TO REPORT A GAS LEAK IN THE VICINITY OF THE LEAK. | |
2. FOLLOW ALL WARNINGS AND INSTRUCTIONS MARKED ON THE PRODUCT. | SAVE THESE INSTRUCTIONS | ||
3. UNPLUG THE PRODUCT FROM THE WALL OUTLET BEFORE CLEANING. DO NOT USE | |||
|
|
| |
TELEDEX TRIMLINE I DIAGRAM
HEARING AID COMPATIBLE HANDSET
MUTE KEY
Deactivates handset/speakerphone microphone for privacy during calls.
REDIAL KEY
To automatically redial last number dialed
FLASH KEY
For programming of FLASH duration.
See instructions for programming details.
DIAL KEYS (DTMF PAD)
For dialing phone numbers.
HANDSET VOLUME KEY
Changes handset volume by pressing repeatedly.
RING VOLUME
Adjusts the ringer volume to Low or High setting.
MESSAGE WAITING LIGHT (optional)
Signals that a message is waiting for retrieval. See your system administrator for instructions on retrieving messages.
DATA PORT
HOOK SWITCH
| FOR CUSTOMER SERVICE CALL |
Part Number |
Teledex, LLC | Telephone: | (408) |
6311 San Ignacio Avenue | Fax: | (408) |
San Jose, CA | email: | sales@teledex.com |
95119 | Internet: | www.teledex.com |