Oricom AM100 manual Hello, this is, To Check the Greeting

Note: The AM100 has two personalized mailboxes.You have an option to have callers leave messages in either of the two mailboxes.

If you want the caller to leave a message in a particular mailbox, your greeting should instruct the callers to press either the “1*” or “2*” button before their message recording. If the caller doesn’t press a key, presses a key other than “1*” or “2*”, or waits longer than 4 seconds before pressing a key, the caller’s message will be automatically recorded in Mailbox 1.

Sample Message:

“Hello, this is ______________.

I can’t come to the phone right now, but please leave your name and phone number after you hear the beep. I’ll return your call as soon as possible. If you wish to leave a message specifically for Bob, press “1*”, for Joan, press “2*”. Thank you for calling.”

Notes:

•The maximum length for an outgoing message is approximately 1 minute and the minimum is about 2 seconds. When the maximum outgoing message length is reached, the system sounds three short tones and plays back the message. Repeat these steps to record a new outgoing message. At the last 10 seconds, the counting numbers will flash.

•If you record your own message and later decide to use the prerecorded message, hold down GREETING button until a beep sounds. Release GREETING button, and the system plays the prerecorded outgoing message. If you want to use a personal greeting, you must record it again.

4.6 To Check the Greeting

1.To check the greeting, press and release GREETING button quickly.

2.Your outgoing greeting will be played back to you, and then

your system will reset to answer incoming calls.

Note: You can stop greeting playback by pressing GREETING button once again.

6