Installation
MOUNTING THE BASE ON A WALL
Note: To mount the base directly on the wall, you need two screws (not supplied) with heads that fit into the keyhole slots on the bot- tom of the base. Drill two holes 315/16 inches (100 mm) apart, one above the other. Then thread a screw into each hole, letting the heads extend about 5/16 inch (7 mm) from the wall.
1 Plug one end of the sup- | Modular Cord Jack | POWER Jack | |
plied modular cord into the | |||
|
| ||
modular cord jack and the |
|
| |
supplied AC adapter’s barrel |
|
| |
plug into the POWER jack on |
|
| |
the back of the base. |
|
|
2 Route the adapter cord and modular cord through the channel slots on the bracket’s narrow end. Wrap the excess modular cord in the groove in the bottom of the base. Route the end of the adapter cord through the channel slot at the bottom of the base.
3Plug the modular cord’s
loose end into the wall plate jack (or a modular phone line jack), align the base’s key- hole slots with the wall plate studs (or the screws in the wall), and slide the base downward to secure it.
4 Plug the adapter into a standard AC outlet. Fully ex- tend the base’s antenna and raise it to a vertical position
8