Duall channell scan

Channel busy indicator

The red LED will flash twice per second to indicate that the channel is in use.

Time-out timer

The time-out timer feature helps extend battery life by preventing accidental transmission.

The radio will emit a continuous warning tone if the button is pressed for more than 60 continuous seconds and will stop transmitting.

The battery level meter

The battery level meter located in the display indicates how much battery power you have remaining to protect the rechargeable battery. When the battery meter has one

segment left, the radio will chirp after releasing or every 10 minutes.

Duplex mode

Repeater stations can re-transmit your signal over a wider area giving you extended range depending on the location, height and availability of the local repeater station. For information on the locations of repeater sites in Australia and New Zealand visit our website.

Your radio supports duplex mode on channels 1 - 8. If the repeater channel in your area is channel 1, when you are in duplex mode the transmit channel will be channel 31.

1.Select the repeater channel in your area (channel 1 to channel 8).

2.Press the button to enter duplex mode, press or to switch between duplex and simplex mode.

For example,

Select channel 1, duplex mode will display: 1. Simplex mode will display 1.

In stand-by, the PMR is set on one set channel with CTCSS code. The PMR will only receive signals transmitted on that channel and CTCSS code. Dual Channel Monitor allows you to monitor a second channel with CTCSS code.

To set dual channel and code

1.Press until display.

2.Pressing the or button will increase or decrease the dual channel.

3.Press again and then press or button to increase or decrease the dual code number.

4.Press to exit the menu and save the dual channel and code combination.

When the Dual Channel Monitor function is activated, the PMR will switch sequentially between the standby channel + CTCSS and the Dual Channel + CTCSS. When there is activity on the Dual Channel

+CTCSS, the active channel will be displayed for 5 seconds. Within this period, you have the possibility to answer the transmission.