Technical Note
FLX – VoIP | Registering with Cisco UC500/CME Series |
| Date: March 13th, 2012 |
This technical note gives a detailed description on how to register a Revolabs FLX conference phone with a Cisco UC 500/CME series. On the UC 500/CME series a SIP extension and user has to be created using the Command Line Interface (CLI). Once that user is created, the FLX can be set up to register with the UC500/CME series PBX.
To perform the tasks described in this document, the user needs to have administrative rights on the Cisco UC500/CME. While the steps in this document are not difficult, we recommend that a trained Cisco administrator should perform them.
The instructions provided here were collected using a Cisco UC560. Other versions of the Cisco UC500/CME series may differ, though the general procedures are the same.
Configuring Cisco UC500 series PBX for FLX Registration
The configuration of SIP devices on the UC500/CME series is straightforward. The SIP CME feature in IOS is used to register the FLX as a generic SIP endpoint.
The following IOS CLI commands are needed on the UC500/CME device. Please note that in your setup the dn numbers and the pool might be different based on other SIP devices you have installed.
1 P a g e