Radio Shack ET-928 owner manual Fm Page 23 Tuesday, August 17, 1999 403 PM

Page 23

43-1098.fm Page 23 Tuesday, August 17, 1999 4:03 PM

Problem

Solution

 

 

 

 

The phone does not work or works

Be sure the base’s phone line cord and

poorly.

AC adapter are correctly and securely

 

connected.

 

 

The handset battery pack does not

Check the charging contacts on the

charge.

handset and base. If they are dirty, clean

 

them with a pencil eraser.

 

 

The handset does not ring or receive

Be sure the handset’s ringer is turned on.

a page.

 

Adjust the base’s antenna so it stands

 

 

straight up.

 

 

 

Move closer to the base.

 

 

 

Move the base away from noise sources.

 

 

 

The battery pack might be weak. Charge

 

the battery pack by placing the handset

 

on the base for 15–24 hours.

 

 

 

Return the handset to the base to reset

 

the security code.

 

 

The handset stops working or works

Move the handset closer to the base.

poorly during a call.

 

Adjust the base’s antenna so it stands

 

 

straight up.

 

 

 

Be sure the handset’s battery pack is

 

charged. (If the battery power is too low,

 

it does not have enough power to light

 

the BATT LOW indicator.)

 

 

The caller’s voice gets cut off and is

Press VOLUME s to turn up the speaker’s

hard to hear when using the speaker-

volume.

phone.

 

Press MUTE on the handset to turn off the

 

 

ET-928’s microphone while the other par-

 

ty is speaking.

 

 

If you still have problems, disconnect the phone. If other phones on the same line work properly, the fault is in this phone or its installation. If you cannot find the prob- lem, take your phone to your local RadioShack store for assistance.

23

Image 23
Contents ET-928 Features Fm Page 3 Tuesday, August 17, 1999 403 PM FCC Statement Read this Before InstallationContents Placing on a Desk Top InstallationInstalling HANDSET’S Antenna Selecting a LocationIllus -- label strain relief Mounting on a Wall PlateIllus -- show modular cord already connected Add illus -- like the one below of previous section Mounting Directly on the WallAdd illus -- like of previous section Preparation Connecting and Charging the Battery PackAdd illus of indicator location Illus -- reduce to fit space Setting the Dialing ModeAdjusting Ringers Turning On/Off the Ringers Setting the Ringers’ VolumeChecking/Setting the Ringer Tone MAKING/ANSWERING Calls Using the HandsetUsing the Speakerphone OperationIllus of handset/base Redial locations Adjusting the Volume Using RedialSwitching Between the Handset and Speakerphone Illus of handset Hold location Illus of base VolumeUsing Flash Using HoldUsing Mute Changing Channels Using Tone Services on a Pulse LineIllus of base MEM location Special FeaturesMemory Dialing Storing a NumberStoring a Pause Using the IntercomTesting Stored Emergency Numbers Chain Dialing Service Numbers Illus of Intercom location Paging from the Base to the Handset Paging from the Handset to the Base Illus -- enlarge Using AN Optional HeadsetProblem Solution TroubleshootingFm Page 23 Tuesday, August 17, 1999 403 PM OUT of Range Indications Care and Maintenance Illus like 1097-019 w/batt installed Replacing Battery PackLightning FCC Wants YOU to KnowRadioShack Division of Tandy Corporation Fort Worth, Texas