Cautions:
You must use a Class 2
!power source that supplies 9V DC and delivers at least
200 mA. Its center tip must be set to positive and its plug must fit the tele- phone's DC 9V jack. The supplied adapter meets these specifications. Using an adapter that does not meet these specifications could damage the telephone or the adapter.
•Always connect the AC adapter to the telephone before you connect it to AC power. When you finish, dis- connect the adapter from AC power before you disconnect it from the telephone.
Plug the barrel plug of the supplied adapter into the DC 9V jack on the back of the telephone. Plug the other end into the AC outlet.
DC 9V Jack
SETTING THE DIALING MODE
Set T/P (Tone/Pulse) for the type of ser- vice you have. If you are not sure which type you have, do this simple test.
1.Set T/P to T. Lift the handset and lis- ten for a dial tone.
2.Press any number except 0. If your phone requires that you dial an access code (9, for example) before you dial an outside number, do not press the access code number either.
3.If the dial tone stops, you have
T.
If the dial tone continues, you have pulse service. Set T/P to P.
RECEIVER VOL
SETTING THE RINGER
If you do not want to hear the phone ring, set RINGER to OFF. You can still make calls with the ringer off, and you can answer calls if you hear another phone on the same phone line ring.
If you want to hear the phone ring, set RINGER to the desired volume (HI or
LO).
SPEAKER VOL T/P RINGER
SETTING THE VOLUME
Slide RECEIVER VOL to LO (low), MED (medium), or HI (high) as desired.
Slide SPEAKER VOL to set the volume as desired.
6 | Preparation | |||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|