Mounting the Phone, Using the Phone | Radio Shack ET-899, ET-898

MOUNTING THE PHONE

Desk Mounting

USING THE PHONE

Modular

Telephone

Jack

Wall Mounting

(With or Without Wall Plate)

Short Line Cord (supplied)

3/16" (5 mm)

315/16" (100 mm)

3/16" (5 mm)

Note: The USOC number of the jack to be installed is RJ11C (RJ11W for a wall jack).

CAUTION

RISK OF ELECTRIC SHOCK

DO NOT OPEN

This symbol is intended to inform you that parts inside the telephone present a risk of electric shock.

Switch to TONE or PULSE to match the type of service you have. If you have pulse (rotary) service, you can switch to TONE during a call to use tone services.

Press for special services such as Call Waiting.

Press REDIAL to dial the last number dialed (up to 31 tone or 32 pulse digits).

Plug the handset cord into the jacks on the handset and base.

Set RINGER to HI/LO/OFF for a high- or low-volume ring, or to turn off the ringer. You can make calls with the ringer off, and you can receive calls if you hear another phone on the same line ringing.

Press to hang up.

Press FLASH to produce a timed switchhook sig- nal for special services such as Call Waiting.

Note: If you do not subscribe to any special ser- vices, pressing FLASH might disconnect the call.

Press VOLUME to adjust the volume to a comfortable listening level — normal, high, or the highest.

This symbol is intended to alert you to important operating and servicing instructions included in the papers with the telephone.

RadioShack is a registered trademark used by Tandy Corporation.