Using Mute, Using Flash, Paging | Radio Shack ET-1124 instruction

Notes:

•The redial memory holds up to 32 digits, so you can redial long-dis- tance as well as local numbers.

•The redial memory also holds pause entries. See “Entering a Pause” on Page 13.

USING MUTE

To talk to someone in the room without the person on the other end of the phone line hearing your conversation, press MUTE. The TALK/BATT indicator flashes. Press MUTE again or TALK to resume your phone conversation.

USING FLASH

FLASH performs the electronic equiva- lent of a switchhook operation for spe- cial services, such as Call Waiting.

For example, if you have Call Waiting, press FLASH to answer an incoming call without disconnecting the current call. Press FLASH again to return to the first call.

Note: If you do not have any special phone services, pressing FLASH might disconnect the current call.

USING TONE SERVICES ON A PULSE LINE

Some special services, such as bank- by-phone, require tone signals. If you have pulse service, you can still use these special tone services by following these steps.

1.Be sure DIAL MODE is set to P (pulse).

2.Dial the service’s main number.

3.When the service answers, press TONE. Any additional numbers you dial are sent as tone signals.

4.After you complete the call, return the handset to the base or press TALK. The phone automatically resets to the pulse mode.

PAGING

To page the person who has the hand- set (or to locate the handset when the phone is not in use), press PAGE/FIND on the base for less than 2 seconds. The handset beeps for about 5 seconds. To sound the beep for 1 minute, press PAGE/FIND more than 2 seconds. Or, hold down PAGE/FIND for over 1 minute to make the handset beep until you re- lease PAGE/FIND.