Radio Shack ET-596 owner manual Mounting the Base Directly on the Wall

43-696a.fm Page 10 Friday, August 13, 1999 12:48 PM

7.Raise the base’s antenna to a ver- tical position and fully extend it.

Mounting the Base

Directly on the Wall

To mount the base directly on the wall, you need two wood screws (not sup- plied) with heads that fit into the key- hole slots on the bottom of the base.

1.Drill two holes 315/16 inches apart. Then thread a screw into each hole, letting the heads extend about 5/16 inch from the wall.

5/16"

2.If you have a single 2-line modular jack close by, plug one end of the supplied modular cord into the

TEL LINE 1/2 jack.

Note: When you make this con- nection, you should not connect another modular cord to the TEL LINE 2 jack or phone operation will be erratic.

If you have two separate 1-line modular jacks, plug one end of the supplied modular cord into the TEL LINE 1/2 jack and plug another modular cord (not sup- plied) into the TEL LINE 2 jack.

315/16"

5/16"

10

If you have only one 1-line modu- lar jack, plug one end of the sup- plied modular cord into the TEL LINE 1/2 jack to use line 1, or to the TEL LINE 2 jack to use line 2.