1088A90A.fm Page 11 Tuesday, August 17, 1999 8:46 AM
SETTING THE DIALING MODE
Set DIAL MODE on the back of the base for the type of service you have. If you are not sure which type you have, do this test.
1.Set DIAL MODE to T.
SETTING THE RINGER TONE/VOLUME
You can select one of four different ringer tone/volume settings while the phone is not in use.
2.Lift the handset and listen for a dial tone.
3.Press any number other than 0.
Note: If your phone system requires that you dial an access code (9, for example) before you dial an outside number, do not press the access code either.
If the dial tone stops, you have
If the dial tone continues, you have pulse service. Set DIAL MODE to P.
Press VOLUME to hear the current ringer setting.
Repeatedly press VOLUME until you hear the desired ringer setting. Each time you press VOLUME, the ringer changes in this order:
High-volume,
High-volume,
Low-volume,
11