ADJUSTING THE
HEADSET
1.Place the headset on your head with the earpiece over either ear.
2.Adjust the headset band until it rests with almost no pressure on your ear and the top of your head.
If the headset is loose, remove it and adjust it inward slightly to tighten it. If the headset is tight, gen- tly pull the headset band out to loosen it.
3.Hold the headset in place, and adjust the microphone boom until it is about even with your chin. Experi- ment until you find the most comfort- able position.
Lapel Clip
Caution: The microphone boom swivels on the headset. Do not bend the microphone boom while you adjust it.
4.Attach the lapel clip to your clothing. Leave enough slack in the cord so you can move your head without pulling the headset.
Note: When you are not using the head- set, place it on the headset hanger. Oth- erwise (if you just lay it down on a flat surface, for example), you might have to repeat these adjustments.
SETTING THE DIALING MODE
Set TONE/PULSE for the type of service you have. If you are not sure which type you have, do this simple test.
1.Set TONE/PULSE on the side of the dialer to TONE.
2.Press TALK/HANG UP so the green IN USE indicator lights and listen for a dial tone.
6