Installation Steps
Installation of your ClearSounds™ CL1100 Phone is easy. There are some basic steps you need to take when you
Check Parts list.
•Install (4) AAA Alkaline batteries (not included). Batteries are required if you wish to increase the ringer level an additional 10 dB.
•Set the dialing mode.
•Choose desktop or wall mount.
•Program your memory dial buttons.
•Set ringer.
•Set your volume and tone.
PARTS CHECK LIST
Check to make sure your package includes the items described below. You should have a TELEPHONE BASE, TELEPHONE HANDSET, 6ft LONG TELEPHONE LINE CORD, 8 inch SHORT TELPHONE LINE CORD, HANDSET CURLY CORD, WALL PLATE ADAPTER, AND OWNERS MANUAL
INSTALLING THE OPTIONAL BATTERIES
(required if you wish to increase the ringer level up to 85 dB)
1.Open the battery compartment door located on the bottom of your phone by pulling back the latch.
2.Insert correctly (4) AAA alkaline batteries (not included) in the battery compartment (See diagram #1). Be sure to observe battery polarity as imprinted on the base of the compartment.
3.Snap the battery compartment door back in place.
4.The batteries will last approximately 1 year before needing replacement.
5. Note: The telephone ringer will operate with or without batteries.
6.Note: When replacing batteries, you will need to remove the Wall Plate adapter if in use. Slide the phone upward to remove & disconnect the phone from your existing
wall jack. Slowly slide the Wall Plate adapter down until it unsnaps from the phone. Follow the directions above.
6