GE 2-9762, 2-9750, 2-9766, 2-9764, 2-9765, 2-9763 manual Wall Mount Installation

Page 7

WALL MOUNT INSTALLATION

If you don't charge the handset battery properly (for 12 hours) when you first set up the phone, performance of the battery will be compromised.

1.Plug the telephone line cord into a modular wall jack.

2.Connect the power supply adapter into an AC outlet.

3.You can wrap the extra cord around the cord wrap in the base plate or leave the extra cord hanging.

If you use the cord wrap: remove the base plate, wrap the cord, and re-attach the base plate.

4.Slip the mounting holes over the wall plate posts and slide the unit down firmly into place. (Wall plate not included.)

5.Set the TONE/PULSE switch to TONE if you have touch-tone service or to PULSE if you have rotary dial service.

6.Turn on the RINGER switch so the hand- set rings for incoming calls.

7.Place handset in the base to charge for 12 hours. The CHARGE/IN USE light comes on indicating that the battery is charging.

NOTE: The easiest way to fit the telephone line cord into the base plate, is to leave it wrapped up. Just unwrap enough cord to reach the modular wall jack.

PHONECHANNEL

1 ABC 2 DEF 3

GHI 4 JKL 5 MNO6

PRS 7 TUV 8 WXY 9

TONE* OPER0 #

VOLUME

MEMORY

REDIAL

RINGER

FLASH

OFF

ON

 

6

1

3

2

5

7

PAGE / FIND

 

 

CHARGE

 

IN USE

7

Image 7
Contents Channel Cordless Telephone User’s Guide FCC Registration Information Introduction Table of ContentsBefore YOU Begin Getting StartedModular Jack Requirements Raise the base antenna DESKTOP2 InstallationWall Mount Installation Making a Call Cordless Phone BasicsReceiving a Call Paging the Handset Ringer SwitchFlash Button Olume UttonMemory Feature Advanced FeaturesChannel Button Temporary Tone Changing the Battery General Product Care Troubleshooting Guide Handset Sound SignalsHours Causes of Poor Reception Service$14.95 Accessory Order FormTone IndexFor how long after your purchase Limited WarrantyModel 2-9750/62/63/64/65/66 Rev E/S