ELAN Home Systems THP650LS, THP525LS manual Wires Through Holes Shared By High-Voltage Wiring

THP525LS/THP650LS INSTALLATION MANUAL ELAN HOME SYSTEMS

Wiring (cont’d.)

When pre-wiring for a Home Theater, run 14-16AWG stranded speak- er wire from the equipment location (head-end) to each speaker location. Use speaker wall plates in the listening room as termination points and use ELAN PSP6 or PSP12 Precision Panels for neat and accurate speaker wire management at the head-end equipment location.

Note: When pre-wiring for a Home Theater, it is essential to make direct wire runs from the head-end to each speaker. Do not run speaker wires in series or parallel, and do not “daisy-chain” speakers to common wiring.

Bannana

Plug

To

THP525LS/650LS/

650SS

SPK IN

Front

Rear	Rear
Bannana	Bannana
Plug	Plug
	12-16 AWG
	Stranded
	Speaker Wire

Speaker

Wall Plates

Bannana

Plug

To

Home Theater

Receiver

SPK OUT

Front

WARNING: Do Not Run Speaker

Wires Through Holes Shared

By High-Voltage Wiring!

There are instances where TheaterPoint speakers will be connected directly to an amplifier. Use a high quality speaker cable of equal lenghth for each Left and Right speaker directly from the amplifier to each speaker. The use of spade lugs or bannana plugs is recom- mended.

Page 6 © ELAN Home Systems 2005 • All rights reserved.