IN CASE OF
DIFFICULTY
If your Telephone does not work properly, follow the Service Checklist. If it is still inoperative then disconnect the Telephone and try another telephone to determine if the problem is with the telephone line. If it is the telephone line, notify the telephone company for service.
If the Telephone continues to malfunction, please make sure you have followed all the instructions in this manual to correct the problem.
If you continue to have problems, refer to the sewice information on page 17 of this guide and the Telephone must be disconnected.
A. Semite Checklist
TELEPHONE
PROBLEM
1.No Dial tone
2.Phone does not dial
3.You cannot be heard by other party
4.Memory Dialing Problems
5.Incoming and Outgoing voice volume is too low
6.Phone does not ring
SOLUTION
●Check Cords to make sure they are inserted correctly.
●Does HOOK SW/~H extend fully when handset is removed from cradle?
●Check PULSE~NE switch. Place in the PULSE position.
●Check that handset coil cord is fully inserted at both ends.
●Did you program number correctly?
●Did you follow the proper dialing sequence?
●Check that other phones are off hook at the same time. If so, this is a normal condition as volume drops when additional phones are used at once.
●Is RINGER SELEC7 set to OFF position?
7.Tone Feedback Flutter while dialing in pulse mode
8.Loss of Memory
●Are you using too many phones on one line? The total REN of all phones should not be greater than the maximum REN for your calling area. (Usually maximum REN is 5. See FCC Registration Information on back cover.)
●This is normal as power is fluctuating with phone out- pulsing.
●Is battery installed correctly?
●Does battery need to be replaced?
14