Telephone Service

If your Telephone does not work properly, follow the Sewice Checklist. If it is still inoperative then disconnect the Telephone and t~ another telephone to determine if the problem is with the telephone line. If it is the telephofle line, notify the telephone company for semice.

If the Telephone continues to malfunction, please make sure YOU have followed all the instructions in this manual to correct the problem.

If you continue to have problems, refer to the service information on page 15 of this guide and the Telephone must be disconnected.

....

. .. .

	. ...”
			-.
..	. ..	.	. .
	. ..	.	;-
		..:,
..	.	..,.
	:..	. .
	:..

A. Sewice Checklist

TELEPHONE

PROBLEM

1.No Dial tone

2.Phone does not dial

3.You cannot be heard by other party

4.Memory Dialing Problems

5.Incoming and Outgoing voice volume is too low

6.Phone does not ring

7.Tone Feedback Flutter while dialing in pulse mode

SOWTION

. Check Cords to make sure they are inserted correctly,

●Does HOOK SWITCH extend fully when handset is removed from cradle?

●Check PULSE~NE switch. Place in the PULSE position.

●Check that handset coil cord is fully inseded at both ends.

●Did you program number correctly?

c Did you follow the proper dialing sequence?

●Check that other phones are off hmk at the same time. If so, this is a normal condition as volume drops when additional phones are used at once.

. Is RINGER SELECT set to OFF position?

●Are you using too many phones on one line? The total REN of all phones should not be greater than the maximum REN for your calling area. (Usually maximum REN is 5. See FCC Registration Information on page 16.)

●This is normal as power is fluctuating with phone out- pulsing.

8. Loss of Memory	.	Is batte~ installed	correctly?
	●	Does battery need	to be replaced?