INSTALLATION & SETUP
1.Make sure that the power supply cord is plugged into the POWER 12V DC jack on the base and into an AC outlet.
2.Plug the telephone line cord into the PHONE LINE jack on the base and into a modular jack.
3.Set the TONE/PULSE switch to TONE for
4.Slide the base RINGER switch to ON if you want the unit to ring for incoming calls. (The RINGER switch is located on the same side of the base as the antenna.)
5.Raise the base antenna.
5
RINGER
OFF ON
4
TONE PULSE
PHONE LINE POWER DC 12V
3
NOTE: For conve- nience, attach the headset hook to the slots at the back of the base. You can rest the headset here when you are not using it.
1
2
NOTE: Use only the Thomson
6