WALL MOUNT INSTALLATION
1.Remove the handset hook; turn it upside down, and put it back in the slot. You need to do this so the handset doesn’t fall out of the base.
2.Plug the short telephone line cord into the jack marked PHONE LINE on the back of the unit and plug the other end into a modular wall jack.
3.Connect the power adapter to the POWER 9V DC jack on the phone.
4.Install the base plate by putting the tabs into the slots on the top of the unit first, and then snapping the bottom tabs into place.
5.Slip the mounting holes over the wall plate posts and slide the unit down firmly into place. (Wall plate not included.)
6.Set the T/P switch to T for
9
12
3
5
4
7
10
IN USE
CHARGE/
PAGE
PAGE
7.Plug the other end of the power adapter into an AC outlet.
8.Set RING switch to ON.
9.Raise the base antenna.
10.Place handset in the base to charge for 12 hours. The CHARGE/PAGE light comes on to indicate that the battery is charging. You must charge the handset battery continuously (without using the phone) for 12 hours when you set up the phone.
6