TM
| INSTALLATION INSTRUCTIONS | VISION WALL | |
| |||
| Sheet 4 of 4 | ||
|
| ||
|
|
|
|
| IMPORTANT: Read carefully before installing fixture. Retain for future reference. | 12/29/03 | |
|
|
| |
|
| ||
WARNING: Make certain power is OFF before starting installation or attempting any maintenance.
Adjustment Of Light Throw
Your Vision Wall luminaire has an adjustable forward light throw.
TM
|
|
| VISION WALL | ||
INSTALLATION INSTRUCTIONS | |||||
Sheet 1 of 4 | |||||
|
|
| |||
|
|
|
|
| |
IMPORTANT: Read carefully before installing fixture. Retain for future reference. |
| 12/29/03 |
| ||
|
| ||||
General: Upon receipt of fixture thoroughly inspect for any | Safety: This fixture must be wired in accordance with | ||||
freight damage, which should be brought to the attention of | the national electrical code and applicable local codes | ||||
the delivery carrier. Compare the catalog description listed | and ordinance. Proper grounding is required to insure | ||||
on the packing slip with the fixture label on the housing to | personal safety. Carefully observe grounding procedure | ||||
assure you have received the correct merchandise. | under installation section. All work should be done by a | ||||
| qualified electrician. |
|
| ||
1. Obtain a 3/16" allen wrench.
Adjustment Screw
WARNING: Make certain power is OFF before starting installation or attempting any maintenance.
2. Locate the stainless steel button head screw on the outside of the fixture (See Fig. 4).
3. Turn the screw clockwise to pivot the reflector and throw the light forward.
4. You may monitor the reflector rotation by viewing the | Fig. 4 |
bottom edge of the reflector and the indicator located |
|
inside the fixture. This is viewable through the glass |
|
(See Fig. 5). |
|
5. Rotating the screw
Degree Indicator
Fig. 5
CAUTION:
Prior to installing lamp in the fixture, verify that lamp source and wattage correspond with the fixture label. Lamp should be screwed securely into the socket. Do not over tighten.
WARNING:
Recheck to be sure that the fixture has been wired properly. Improper wiring may result in ballast failure which voids all warranties.
Cleaning
Your Vision Wall Luminaire has three different types of mounting interface:
1.Standard
2.Embedded
the wall (Optional Accessory VWM/EM) (See Fig. 2).
3. Thru Way
NOTE:
Please refer to your mounting kit for specific instructions.
Conduit run by others
4" J Box (By Others) | Standard Mount Kit |
screws to J Box |
Embedded Mount Kit
Fig. 2
EMBEDDED MOUNT
VWM/EM
Thru Way Mounting
The reflector and door glass may be cleaned with any suitable
CAUTION:
Do not use abrasive, strong alkaline or acid cleaners.
These instructions do not claim to cover all details or variations in the equipment, procedure, or process described, nor to provide directions for meeting every possible contingency during installation, operation or maintenance. When additional information is desired to satisfy a problem not covered sufficiently for user’s purpose, please contact your nearest representative.
www.cooperlighting.com
Customer First Center 1121 Highway 74 South Peachtree City, GA 30269 770.486.4800 FAX 770.486.4801 AVU033142
Fig. 1 | Fig. 3 |
STANDARD MOUNT | |
| VWM/TB |
These instructions do not claim to cover all details or variations in the equipment, procedure, or process described, nor to provide directions for meeting every possible contingency during installation, operation or maintenance. When additional information is desired to satisfy a problem not covered sufficiently for user’s purpose, please contact your nearest representative.
AVU033142