Dectom.qxd 2/09/99 15:59 Page 11
Installing &
Adjusting
Your Phone
Desk/Table Top Installation
1. | Plug in the AC adaptor cord into the |
|
| plug in the bottom of the base, labelled |
|
| icon | Telephone |
2. | Plug the AC adaptor into a standard | Jack |
|
230/240 VAC wall outlet.
3.Place the AC adaptor cord around the strain relief.
4.Charge the battery (refer to Charging the Battery Pack).
5.Plug one end of the telephone cord into the tel line jack on the bottom of the base.
6.Plug the other end of the cord into your telephone jack on the wall.
7.Place the line cord around the strain relief.
Use only the AC Adaptor supplied with this phone.
CAUTION
8. Set the base on a desk or tabletop and place the handset into the base as shown.
Installing the Handset Battery Pack
1.Press in on the battery cover and slide the cover down until it comes off.
2.Align the plastic connector of the Metal Nickel Hydride battery pack with its socket and plug it in.
3.Place the battery pack inside.
4 Slide the battery cover on until it snaps into place.
Be sure to fully insert the battery plug into the socket.
NOTE
AC Adapter
11