Ericsson 230i manual If subscription fails

Language

At this point you may wish to change the language of your handset.

Getting started

mount. Due to possible interference, do not place the cordless phone near audio or video equipment.

3.If you place the base station on a wall, screw the wall mount to the wall.

4.Connect the telephone cable to the base station’s telephone socket and to

the ISDN network terminator. Connect the power cord to the power plug socket of the base station.

										V
										s
								e		rkLine
								Us	etwo	Power
								N
				5. Connect the desk stand to the base stationeor connect the base station to the
							ercial
					wall mount. Locate the lower hooksilfirst.
					For the desk stand, route the cables through the slots at the back.
						m	b
				6. Place the handset into the base station as shown in the illustration. Make
						m
					sure that the handset is switched off.
							Mo
				7. Plug the power adaptor into the wall socket.
					The red Colight on top of the base station should now be on continuously. If
					you see a red, flashingsslight, there is a fault with the telephone line
					connection.	e
Home		1			for
			t		After a fewinminutes the handset will subscribe itself to the base station and
					the red light on the top of the base station will go off.
			No		s
				8. Leave the handset in the base station for at least 3 hours to charge the bat-
					tery for the first time.
					Bu
				When the battery is charged, the handset is ready for use. For more informa-
			n
			o	tion about charging the battery, please refer to “Battery” on page 9.
		ss		If subscription fails
				Normally the handset automatically subscribes to the base station when the
	c			cordless phone is installed. However if automatic subscription fails (the signal
ri
				strength indicator is not visible in the display), you have to manually sub-
E				scribe the handset to the base station see “Subscribing a DT200 handset to the
				230i base station” on page 29.

6