Cobra Electronics CP-705 operating instructions Quick Set-Up Guide, Wall Mounting Instructions

Installation Information (Cont.)

•Never install telephone wiring during a lightning storm.

•Never install telephone jacks in wet locations unless the jack is specifically designed for wet locations.

•Never touch uninsulated telephone wires or terminals unless the telephone line has been disconnected at the network interface.

•Use caution when installing or modifying telephone lines.

Quick Set-Up Guide

The following basic steps enable quick and easy installation of your new Cobra INTENNA cordless phone for use on a desk or countertop. You are encouraged to review this complete instruction manual to become familiar with all of the operating instructions and features of your new phone.

NOTE: Before using, connect your new phone to AC power — see instruction below — to charge it overnight (at least 12 hours) for optimum conditioning of the rechargeable batteries inside the cordless handset.

•Insert the round connector of the power adapter into the POWER jack (at the rear of the cordless phone’s base; see diagram #1 below) and plug the power adapter into a standard 110V household electrical outlet. Then place the handset into the base so the CHARGE indicator lights.

		Pulse/Tone Switch
		AC Power Jack
		Diagram #1:
Ringer		Connecting
On/Off Switch		your phone's
OFF ON	P T	AC power
RINGER	PULSE/ POWER
	TONE 9VDC	adapter cord

STOP: Charge your phone overnight before proceeding with installation.

•After charging, remove the twist-tie from the phone cord and plug the modular telephone connector into the phone jack on your wall.

•Make sure that the RINGER switch is ON (located at the rear of the base).

•Set the PULSE/TONE switch (also at the rear of the base) for proper opera- tion (see page 7 for details).

Wall Mounting Instructions

The following steps enable installation on a new or existing telephone wall- mounting plate or directly onto a wall. (Your Cobra INTENNA is designed to be used with any AT&T, GTE, local phone company or other wall-mounting plates that can be purchased from most local electronics stores.)

•Plug modular phone connector into telephone wall jack.

•Align mounting studs on the plate to the holes on the bottom of the INTEN- NA base; push base onto studs and slide down on the wall plate.

Modular Phone Jack

Diagram #2: In-

stallation on a telephone wall- mounting plate

Mounting Studs

•Wrap doubled cord around bottom of base. Cord can be hidden between bottom of base and wall-mounting plate.

•Attach the power adapter to the POWER connection (on the base of the phone) and plug into a household AC power outlet.

•To install directly on any wall, you’ll need to provide two screws and wall anchors; follow these steps:

—Drill two holes 3 1/4” apart and insert the wall anchors.

—Drive the screws into the anchors until the head of each screw is protruding about 1/8” from the wall.

—Align the holes in the cordless base over the screw heads; push base in and slide down on screws (see diagram #3).

—Plug modular phone connector into telephone wall jack; attach the power adapter to the POWER connection (on the base of the phone) and plug into to a household AC power outlet.

Screw Heads

Diagram #3: Installation directly on a wall

Modular Phone Jack

(2) (3)