Quick Set-Up Guide

The following basic steps enable quick and easy installation of your new Cobra Intenna Cordless Phone for use on a desk or countertop. You are en- couraged to review this complete instruction manual to become familiar with all of the operating instructions and features of your new phone.

NOTE: Before using, connect your new system to AC power (see instruc- tions below) to charge it overnight (at least 12 hours) for optimum condi- tioning of the rechargeable battery inside the cordless handset.

1Insert round connector of power adapter into POWER jack (at rear of cordless phoneÕs base; see diagram #1 below). Plug power adapter into a standard 120 VAC household electrical outlet. Then place handset in base so CHARGE indicator lights (see p. 12).

BASE UNIT—

REAR VIEW

➂ ON/OFF

RINGER SWITCH

PULSE/TONE

SWITCH

ELECTRICAL

OUTLET

ADAPTER

HANDSET

Diagram #1

Connecting

power and

telephone

①

DC POWER JACK

MODULAR

PHONE JACK

2After charging, remove the twist-tie from the phone cord and plug the modular telephone connector into the phone jack on your wall (see above).

3Make sure that the RINGER switch is ON (located on base; see p. 11 for details).

4 Set the PULSE/TONE switch (at the rear of the base) for proper operation (see page 11 for details).

Note: Make sure you have charged hand- set in base 12 hours before using.

5 Install the 9V battery for Power Protectorª operation in the base as shown in the illustration.