Quick Set-Up Guide

The following basic steps enable quick and easy installation of your new Cobra Intenna Cordless Phone for use on a desk or countertop. You are en- couraged to review this complete instruction manual to become familiar with all of the operating instructions and features of your new phone.

NOTE: Before using, connect your new system to AC power (see instruc- tions below) to charge it overnight (at least 12 hours) for optimum condi- tioning of the rechargeable battery inside the cordless handset.

1Insert round connector of power adapter into POWER jack (at rear of cordless phoneÕs base; see diagram #1 below). Plug power adapter into a standard 120 VAC household electrical outlet. Then place handset in base so CHARGE indicator lights (see p. 12).

BASE UNIT—

REAR VIEW

RINGER	PULSE/
RINGER	TONE
		POWER
OFF ON	P T	POWER
OFF ON	P T		9V DC
			9V DC

➂ ON/OFF

RINGER SWITCH

HANDSET

Diagram #1

Connecting

power and

telephone

①

DC POWER JACK

4PULSE/TONE SWITCH

①

	2
ELECTRICAL	MODULAR
ELECTRICAL	PHONE JACK
OUTLET

2After charging, remove the twist-tie from the phone cord and plug the modular telephone connector into the phone jack on your wall (see 2 above).

3Make sure that the RINGER switch is ON (located on base; see p. 11 for details).

4Set the PULSE/TONE switch (at the rear of the base) for proper opera- tion (see page 11 for details).

Note: Make sure you have charged handset in base 12 hours before using.