Auto Line Feed System
P
line cutter
How the automatic line feed works (P)
1.When initially switching on the trimmer, a small length of line is fed out.
2.A ‘clattering’ noise will be heard when the nylon line hits the line cutter. DO NOT BE ALARMED this is quite normal. After approximately 5 seconds the line
will be cut to the correct length and the noise will re- duce as the motor reaches full speed.
•Make sure the motor is up to full speed before trim-
ming or edging.
3.If the noise of the nylon line being cut cannot be heard, more line will need to be fed out.
4.To feed more line, it is first necessary to to allow the motor to stop completely, then
5.Repeat step 4. until you hear the line hitting against the cutter. (Do not repeat this procedure more than 6 times)
6.If problems are experienced with the automatic line feed refer to Fault Finding Chart.
Manual line feed
Q
manual line feed button
To manually feed the nylon line (Q)
1.If required line can be fed out manually.
2.To operate, press and release manual line feed button, whilst gently pulling on the line until it reaches the line cutter.
3.If the line extends past the line cutter, too much line has been fed out.
4.If too much line is fed out, remove the spool cap and click spool
Cutting Head
To remove spool cap
1.Press and hold in the two cap release latches. (R).
2.Pull cap away from the spoolholder. (R).
When refitting the spool cap
1.Keep all areas of the cap and spoolholder clean. Fail- ure to do so may prevent the cap being securely lo- cated in the spoolholder.
2.Replace the cap, pressing firmly DOWN towards the spoolholder to ensure cap is fully located.
3.Check that the cap is correctly fitted by trying to remove it without depressing the two latches.
To replace nylon line.
For your convenience it is recommended you buy spool and line complete. Nylon line only is also available. Both are available from Husqvarna UK Ltd. stockists.
To fit spool and line complete:
1.Remove old spool.
2.Place new spool into spoolholder with cut out area of the spool in line with eyelet as shown in figure S.
3.Release line from cleat and feed line through eyelet (S).
•Ensure spool is fully located by gently rotating it during fit- ment, whilst keeping the spoolholder steady.
4.Refit the cap.
To fit nylon line only:
• Remember! Your product is designed to use only nylon line with a maximum diameter of 1.5mm. Use only gen- uine Flymo nylon line.
1.Take approximately 10 metres of line. Insert 15mm of line into the hole in the spool (T) and wind line in the di- rection of the arrows on the top of the spool. Leave ap- proximately 100mm of line unwound and place into cleat as illustrated in figure T1.
2.Care should be taken to ensure that the line is neatly coiled on the spool. Failure to do so will impair the effi- ciency of the automatic line feed.
3.Then fit spool as described in ‘To fit spool and line com- plete’, section above.
Always return the product to its normal operating posi- tion before switching on.
R
Cap
Cap release
latch
Spool
Spoolholder
Eyelet
S | Cut out area |
| of spool |
| Eyelet |
T1 | Cleat |
T |
|