Basic Operation, Replace the handset battery

INITIAL SETUP (Continued)

Replace the handset battery

1. Remove the battery compartment lid.

2.Detach the old battery from the battery compartment by using the ribbon linked to the battery.

3.Place the new battery into the compartment. Follow the direction and make sure the contacts of the battery touch the contacts of the compartment.

4.Replace the lid.

5.Place the handset on the base station for 15 hours.

CHARGE

The /IN USE indicator in base will light.

Battery ribbon

Battery contacts

BASIC OPERATION

Before using the phone

Register

Your handset has been registered to the base at the factory. Please verify the link is still valid before use.

1.Place the handset close to the base station. The antenna icon in the display should appear.

2.Press . Verify that you get a dial tone and the IN USE indicator lights. The display will show "IN USE" and a call timer.

Your handset is ready to use.

3.Place a call or press to hang up.

If your handset does not register to the base, please see page 36 TROUBLE SHOOTING for help and/ or try the following procedures to register the handset:

Lift the handset from the base charging cradle. Press and hold the PAGE button in the base for 10

CHARGE

seconds until the /IN USE LED flashes. Please complete the registration within 1 minute.

	Press	To
	MENU	enter MENU
		scroll to SETUP
	MENU	enter SETUP
		scroll to REGISTER
	MENU	enter REGISTER
	MENU	enter NEW REGISTER
	MENU	select BASE 1 for the first base unit
	MENU	input PIN code, default is 1234
	key 0-9	input PIN code, default is 1234
	key 0-9	confirm
	MENU	confirm
	MENU

Your handset is now searching for the base. If successful you will hear a long beep confirmation tone. If not successful, you will hear a 3 beep error tone. Please try again.

Dial mode

Depending on the telephone system, you may need to set the dial mode TONE or PULSE to match. Default is TONE. If you are not sure the dialing system, contact your local telephone company.

Press	To
MENU	enter MENU

scroll to SETUP

MENU	enter SETUP

scroll to DIAL MODE

MENU	enter DIAL MODE

select TONE or PULSE

confirm

exit

NOTE: For CLT-D6222 and CLT-D6223 multi-handsets, you must set the dial mode for each handset.

11	12