A & T International TL32350 manual Telephone base and charger installation, Important Information

Telephone base and charger installation

Install the telephone base and charger as shown below. If you subscribe to high-speed Internet service (DSL - digital subscriber line) through your telephone line, you must install a DSL filter between the telephone line cord and the telephone wall jack. The filter prevents noise and caller ID problems caused by DSL interference. Please contact your DSL service provider for more information about DSL filters.

The telephone base comes ready for tabletop use. If you want to mount your telephone on a wall, refer to Wall mount installation in the user’s manual for details.

Telephone wall jack

Plug the other end of the telephone line cord into a telephone wall

jack.

A DSL filter (not included) is required if you have DSL high-speed Internet service.

Telephone line cord

Route the cords through the slot.

Electrical outlet not controlled by a wall switch

Plug the large end of the larger power adapter into an electrical outlet not controlled by a wall switch.

Plug one end of the telephone line cord into the TEL. LINE jack on the back of the telephone base.

Plug the small end of the larger power adapter into the power jack on the back of the telephone base.

Plug the large end of the smaller power adapter into an electrical outlet not controlled by a wall switch.

Route the cord through the slot.

Ensure the small end of the smaller power adapter is plugged into the power jack on the back of the charger.

Raise the antenna.

IMPORTANT INFORMATION:

•Use only the power adapters provided with

this product. To obtain a replacement, visit our

website at www.telephones.att.com

or call 1 (800) 222-3111. In Canada,

dial 1 (866) 288-4268.

•The power adapters are intended to be correctly oriented in a vertical or floor mount position. The prongs are not designed to hold the plug in place if they are plugged into a ceiling or an under-the-table or cabinet outlet.