Audiovox DST 961 manual Dialing from Memory, Memory Speed Dialing Changing Stored Numbers

DIALING FROM MEMORY

.-Press TALK to get dial tone.

.Press MEM.

.Enter a 2 digit location number (00..20)

.The number stored in that location will be automatically dialed.

MEMORY (SPEED) DIALING CHANGING STORED NUMBERS

To change or replace a stored number, simply store a new number in the desired memory location following the instructions

listed in STORING MEMORY DIAL NUMBERS.

DELETING STORED NUMBERS

To delete a stored number from memory do the following:

.Press PROG to enter program mode.

.Enter the memory location (00..20).

.Press MEM to exit program mode.

NOTE:Stored numbers are retained in memory even if the base loses its power or the handset battery is removed.

STORING SPECIAL CODES

To insert a pause in a phone number, press HOLD at the appropriate point when entering the number. This inserts a 2 second pause. For longer pauses, press HOLD two or more times. Each press makes the pause 2 seconds longer, and is treated as a stored digit.

If your phone is connected to a PBX you can store the PBX access number and a

pause before the phone number. For

example, to store 9-PAUSE-555-1234 in memory location 08, do the following:

.Press PROG

.Press 08 (memory location)

.Press 9

.Press HOLD (pause)

.Dial 5551234

.Press MEM

-:::

ADDITIONAL OPERATING TIPS

If the handset is moved to a point where the base unit and handset can no longer communicate, the handset will make a quick series of beeps to signal Out of Range.

OUT OF RANGE WHEN PHONE IS ON

If you are presently engaged in a phone conversation move closer to the base. If the base unit does not communicate with the handset within 25 seconds of losing contact, it will automatically hang up.

OUT OF RANGE WHEN PHONE IS OFF

If the phone is OFF, the handset and base still monitor each other to make sure that they can communicate. If the handset is moved out of range, the handset will make a series of beeps, and then the PHONE and MUTE/ LOW BArT LEOS will flash continually. The

handset will re-Iink with the base automatically once it is brought back within range. The unit will then be able to receive and place calls.

When the base unit is unplugged from the power supply, the handset will give the Out of Range warning beep. Plug the base in again and this will stop.

NOISE OR INTERFERENCE

Your Audlovox DST961 cordless telephone has auto-channel scan circuitry, which will detect excess noise and change the channel of the phone to reduce it. This is done automatically.

Since the Audlovox DST961 is a fully digital phone, it does not suffer from noise associated with regular cordless phones. At times you may experience occasional

rop outs especially at the extreme edges

of the phone range. Simply move closer to the base unit and this will disappear.

AUTOMATIC SECURITY CODING

Your Audlovox DST961 phone is

-JD-

=Jl~