Battery installation and charging

Install the battery as shown below. Once you have installed the battery, you may be able to make and receive short calls. For best performance, charge the handset battery continuously for at least 16 hours.

Set number of rings

You can set the answering system to answer an incoming call after 2, 3, 4, 5 or 6 rings; or toll saver. If you choose toll saver, the answering system answers a call after 2 rings when you have new messages, or after 4 rings when you have no

Quick start guide

CS6120-2/CS6124

Introduction

This quick start guide provides you with the basic installation instructions. A limited set of features are described in abbreviated form.

Please refer to the online user’s manual for complete installation and operation instructions.

Telephone base and charger installation

Install the telephone base and charger as shown below.

Telephone wall jack

Electrical outlet

(not controlled by

1Plug the battery connector securely into the socket.

3Slide the battery compartment cover towards the center of the handset until it clicks into place.

2Place the battery with the wires inside the battery compartment.

4Charge the handset in the telephone base or charger.

new messages.

1.Press MENU when the handset is not in use.

2.Scroll to Answering sys then press SELECT.

3.Scroll to Ans sys setup then press SELECT.

4.Scroll to # of rings then press SELECT.

5.Press CID or to choose 6, 5, 4, 3, 2 or Toll saver and then press SELECT to save.

Record your own announcement

You can use the preset announcement to answer calls, or replace it with your own recorded announcement. The announcement can be up to 90 seconds in length.

1.	Press MENU when the handset is not in use.
2.	Scroll to Answering Sys then press SELECT twice.
3.	Press 7 to record.
4.	After the handset announces, “Record after the tone. Press 5
	when you are done,” speak towards the handset microphone.

A DSL filter	a wall switch)
(not included)
is required if	Telephone base
you have DSL	Telephone base
high-speed	power adapter	Charger
Internet service		Charger
Internet service		adapter
		adapter

Telephone line cord

Charger

Telephone base

Use only the power adapters and batteries supplied with this product.

Charge light remains on when charging.

Enter the handset menu

1.Press MENU when the phone is not in use.

2.Press CID or until the screen displays the desired feature menu.

3.Press SELECT to enter that menu.

•To return to the previous menu, press CANCEL.

•To return to idle mode, press and hold CANCEL.

Set date and time

1.Press MENU when the handset is not in use.

2.Scroll to Settings then press SELECT.

3.Scroll to Set date/time then press SELECT.

4.Use the dialing keys (0-9) to enter the current month, date and year. Then press SELECT.

5.Use the dialing keys (0-9) to enter the hour and minute. Then

press CID or to select AM or PM.

6.Press SELECT to save.

5.	Press 5 when done.
6.	Press 2 to play the recorded announcement; or 7 to record
	again if desired. Press 3 to delete the recorded announcement.
	Press 5 to stop the playback at any time.

IMPORTANT!

Refer to the online user’s manual for a full set of installation and operation instructions. For manual download or customer service, visit our website at www.vtechphones.com or call

1(800) 595-9511. In Canada, go to www.vtechcanada.com or call 1 (800) 267-7377.

96-007701-050-100