Battery installation
Install the battery as shown below.
. Plug the battery connector securely into the socket.
3.Slide the battery compartment cover towards the center of the handset until it clicks into place.
2.Place the battery with the label THIS SIDE UP facing up and the wires inside the battery compartment.
4.Place the handset in the telephone base or charger to charge.
CHARGE light remains on when charging.
Battery charging
Once you have installed the battery, the screen indicates the battery status (see the table below). For best performance, keep the handset in the telephone base or charger when not in use. The battery is fully charged after 11 hours of continuous charging.
Battery indicators | Battery status | Action | ||||||||
|
|
|
|
|
|
|
|
|
|
|
The screen is blank, or | The battery has no or very little | Charge without interruption | ||||||||
displays Put in charger | charge. The handset cannot | (at least 30 minutes). | ||||||||
and |
|
|
| flashes. | be used. |
| ||||
|
|
| ||||||||
|
|
|
|
|
|
|
|
|
|
|
The screen displays | The battery has enough charge | Charge without interruption | ||||||||
Low battery and |
|
|
| flashes. | to be used for a short time. | (about 30 minutes). | ||||
|
| |||||||||
|
|
|
|
|
|
|
|
|
|
|
The screen displays | The battery is charged. | To keep the battery | ||||||||
HANDSET X. |
| charged, place it in the | ||||||||
|
|
|
|
|
|
|
|
|
| telephone base or charger |
|
|
|
|
|
|
|
|
|
| when not in use. |
|
|
|
|
|
|
|
|
|
|
|
Wall mounting (optional)
To mount your telephone on a wall:
. Remove the telephone line cord from the telephone wall jack, and the telephone base power adapter from the electrical outlet (if necessary).
3.Route the telephone line cord through the hole on the wall mount bracket and plug it into the telephone wall jack. Route the power cord out of the telephone base and plug it into an electrical outlet not controlled by a wall switch. 
2.Position the telephone base against the wall mount bracket with the extended tabs marked B on top. Insert the extended tabs marked B on the wall mount bracket into the slots marked B on the back of the telephone base. Push the telephone base down until it clicks securely.
4.Align the holes on the bracket with the standard wall plate and slide the bracket down until it locks securely. Bundle the telephone line cord and power adapter cord neatly
with twist ties.