
Quick Start Guide
i6775
STEP 1 Check package contents
Make sure your phone’s packaging includes the following:
STEP 3 Battery installation
1.Align the two holes in the plug with the socket pins, then snap the plug into place. Place the battery in the compartment with the wires in the upper right corner.
2.Replace cover by sliding it upwards until it clicks into place.
STEP 5 Connect to phone line
Plug one end of the telephone line cord into the telephone line jack at the bottom of the telephone base. Then plug the other
end of the cord into the wall telephone outlet.
Telephone outlet
Step 7 Set the clock
1.Press TIME/SET to listen to the current setting.
2.Press TIME/SET again to indicate changes needed.
3.Press CHANGE to change the day, hour, minute, or year.
4.When you hear the correct setting, press TIME/SET to advance to the next setting.
NOTE:
If you have caller ID service, the time will automatically be updated with the first incoming call after your program the year into the system.
Charger power adaptors (2)
|
|
| Base power adaptor | |
Base unit | Handsets (3) |
|
| |
|
|
| ||
|
| Chargers (2) | Batteries (3) | |
Telephone | Wall mount | Belt clips (3) Quick start User’s manual | ||
line cord | ||||
bracket | guide |
| ||
|
|
Step 8 Record your outgoing announcement
1.Press SETUP, the system announces “Announcement. Press PLAY or press RECORD. To continue setup, press SETUP.”
2.Press REC/MEMO and speak toward the MIC on the base to record an announcement for up to 90 seconds.
3.Press PLAY/STOP / (when finished recording).
NOTE:
For complete feature instructions, please refer to your user’s manual.
STEP 2 Connect power to telephone base/ chargers
Plug the power adaptor into an electrical outlet not controlled by a wall switch, and the connector into the power jack on bottom of the telephone base/chargers.
AC power outlet | AC power outlet | ||||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
NOTE:
•Use only the power adaptors supplied with your VTech telephone.
STEP 4 Charge the battery
1.Place the handset in the base unit/chargers.
2.Charge the battery for at least 16 hours before first use.
STEP 6 Making and receiving calls
Making a call
•Press TALK/FLASH or SPEAKER and listen for dial tone.
•Dial the phone number.
•Dial the phone number.
•Press TALK/FLASH.
Receiving a call
Press TALK/FLASH, SPEAKERPHONE, or any dialing key
except OFF.
Hanging up
Press OFF or place the handset in its base/chargers.
IMPORTANT!
If your product is not working properly:
1.Refer to your user’s manual.
2.Visit our website at www.vtechphones.com or www. vtechcanada.com in Canada.
3.Call our customer service at
issue 0