VTech VT-2420 manual Enter Base ID Code, Registration

Page 6

Getting Started

Enter Base ID Code

1. After charging the Handset, remove it from its Charge Cradle, the screen will display:

2. Press NEW, then enter the 15 digit Base Unit ID code, located on the underside of the Base Unit.

3. Press OK. The Handset will display:

PLEASE WAIT!!

4. Wait approximately 15 seconds. The Handset will display:

FOUND BASE

If the Handset displays: BASE BUSY TRY LATER, this indicates that the system is in use. Wait until the Base Unit is in the idle (on hook) mode, and repeat step 2 to 4.

Congratulations! You can now enjoy the benefits of your VTECH multi-Handset system.

Registration

6

Image 6

Contents Introduction Important Safety Instructions Vtech Communications INC Setup Of The VT2420 Accessory Handset Getting StartedInstallation of Battery Pack in Handset Enter Base ID Code RegistrationHandset Layout AntennaLCD Display Handset Indicators Handset Icons Handset LEDsHeadset Operation OperationBelt Clip Avoid rough treatment Maintenance Taking Care Of Your TelephoneCleaning your telephone Avoid waterPhone Doesnt Work At All Handset Does Not Ring When You Receive a CallCase Of Difficulty No Dial ToneCommon Cure For Electronic Equipment Warranty Statement HOW do I Send MY UNIT, in or OUT of WARRANTY?What does OUR Warranty not COVER? FCC and IC Regulations VTech Communications IncFCC Part FCC and IC Regulations FCC Part IC Industry CanadaFCC and IC Regulations Technical Specifications Nominal Effective RangePage Table Of Contents Issue 2420