IN CASE OF DIFFICULTY
WARRANTY STATEMENT
*Make sure the telephone line cord is plugged firmly into the base unit and the telephone jack. Make sure the power cord is plugged in.
*You may be too far from the base unit.
*You may have too many extension phones on your telephone line to allow all of them to ring. Try unplugging some of the other phones
YOUR CALLER FADES IN AND OUT.
You may be nearly out of range. Move closer, or relocate the base.
YOU HEAR OTHER CALLS WHILE USING YOUR PHONE.
*Replace the handset in the base cradle, wait a few moments and try again.
*Disconnect your base unit from the telephone jack, and plug in a regular telephone. If you still hear other calls, the problem is probably in your wiring or local service. Call your local telephone company.
.
YOU HEAR NOISE IN THE HANDSET, AND NONE OF THE KEYS OR BUTTONS WORK.
*Make sure the power cord is plugged in.
*Your base unit and handset may not be
operating on the same channel. Place the handset in the cradle for a few moments to reset the channel.
COMMON CURE FOR ELECTRONIC EQUIPMENT
Electronics, like people, can sometimes get confused. If the unit does not seem to be responding normally, then try putting the handset in the cradle to
1.Disconnect the power to the base.
2.Disconnect the handset battery.
3.Wait a few minutes.
4.Connect power to the base.
5.Connect the handset battery.
6.Put the handset in the base to re- initialize.
WHAT DOES OUR WARRANTY COVER?
* Any defect in material or workmanship.
FOR HOW LONG AFTER THE ORIGINAL PURCHASE?
*To the original purchaser only - ONE YEAR.
WHAT WILL VTECH DO?
*At our option, repair or replace your unit.
HOW DO I SEND MY UNIT, IN OR OUT OF WARRANTY?
*In the U.S. Call VTECH Communications customer service for Return Authorization at:
in Canada call VTech Electronics at
*Properly pack your unit. Include any cables & accessories which were originally provided with the product. We recommend using the original carton and packing materials.
*Include in the package a copy of the sales receipt or other evidence of date of original purchase (if the unit was purchased within the last twelve months).
*Print your name and address, along with a description of the defect, and include this in the package.
*Include payment for any service or repair not covered by warranty, as determined by VTECH Communications.
*In U.S. ship the unit via UPS Insured, or equivalent to:
VTECH COMMUNICATIONS 8770 SW NIMBUS AVENUE BEAVERTON, OREGON 97008
In Canada ship to :
VTECH ELECTRINICS
RICHMOND, B.C. V6X 1Z9
VTECH Communications assumes no responsibility for units sent without prior Return
Authorization.
WHAT DOES OUR WARRANTY NOT COVER?
*Batteries
*Damage from misuse, neglect, or acts of nature (lightning, floods, power surges, etc.)
*Products which may have been modified or incorporated into other products
*Products purchased and/or operated outside the USA, its territories, or Canada.
*Products serviced by the owner or a service facility not expressly authorized by VTECH Communications
*Products purchased more than 12 months from current date
*Units purchased in “AS IS” condition, or units purchased as “Distressed Merchandise”.
HOW DOES STATE LAW AND PROVINCIAL LAW RELATE TO THIS WARRANTY?
*This warranty gives you specific rights. You may also have other rights which vary from state to state or from province to province.
17
18
TECHNICAL SPECIFICATIONS
FCC AND IC REGULATIONS
FREQUENCY CONTROL
Crystal Controlled Dual PLL Synthesizer
TRANSMIT FREQUENCY
Handset: | 925.05 MHz to 927.75 |
| MHz (All ten channels |
| within this range) |
Base: | 902.3 MHz to 905.0 |
| MHz (All ten channels |
| within this range) |
RECEIVE FREQUENCY | |
Handset: | 902.3 MHz to 905.0 |
| MHz (All ten channels |
| within this range) |
Base: | 925.05 MHz to 927.75 |
| MHz (All ten channels |
| within this range) |
NOMINAL EFFECTIVE RANGE
Maximum power allowed by FCC and IC. Actual operating range may vary according to environmental conditions at the time of use.
SIZE |
|
Handset: | 17.5cm x 5.5cm x 4.5cm |
| (L x W x T) maximum |
| (antenna excluded) |
Base: | 20.3cm x15.2cm x 6.0cm |
| (L x W x T) maximum |
| (antenna excluded) |
WEIGHT |
|
Handset: | 160 grams (excluding battery); |
| 240 grams (including battery) |
Base: | 320 grams |
POWER REQUIREMENTS | |
Handset: | S e l f - c o n t a i n e d n i c k e l - |
| c a d m i u m r e c h a r g e a b l e |
battery supply, 3.6V nominal, 600mAh capacity.
Power Adaptor: 9VDC @ 300mA
SPECIFICATIONS ARE TYPICAL AND MAY CHANGE WITHOUT NOTICE
This equipment complies with Parts 15 and 68 of the Federal Communications Commission (FCC) rules for the United States. It also complies with regulations
A label is located on the underside of the base unit containing either the FCC registration number and Ringer Equivalence Number (REN) or the IC registration number and Load Number (LN). You must, upon request, provide this information to your local telephone company.
This equipment is compatible with inductively coupled hearing aids.
Should you experience trouble with this telephone equipment, please contact:
In the United States:
VTECH COMMUNICATIONS
In Canada:
VTECH ELECTRONICS
for repair/warranty information. The telephone company may ask you to disconnect this equipment from the line network until the problem has been corrected.
Your VTECH VT9112 is designed to operate at the maximum power allowed by the FCC and IC. This means your handset and base unit can communicate only over a certain
distance - which will depend on the location of the base unit and handset, weather, and the construction and layout of your home or office.
FCC Part 15
Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
The equipment has been tested and found to comply with part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try and correct the interference by one or more of the following measures:
*Reorient or relocate the receiving antenna.
*Increase the separation between the equipment and receiver.
*Connect the equipment into an outlet or on a circuit different from that to which the receiver is connected.
*Consult the dealer or an experienced radio / TV technician for help.
19
FCC AND IC REGULATIONS
20
FCC AND IC REGULATIONS
FCC Part 68
The FCC requires that you connect your cordless telephone to the nationwide telephone network through a modular telephone jack (USOC RJ11C or RJ11W).
Your telephone company may discontinue your service if your equipment causes harm to the telephone network. They will notify you in advance of disconnection, if possible. During notification, you will be informed of your right to file a complaint with the FCC.
Occasionally, your telephone company may make changes in its facilities, equipment, operation, or procedures that could affect the operation of your equipment. If so, you will be given advance notice of the change to give you an opportunity to maintain uninterrupted service.
The base unit contains no user serviceable parts. The handset contains a user replaceable battery pack.
If it is determined that your telephone equipment is malfunctioning, the FCC requires that it not be used and that it be unplugged from the modular jack until the problem has been corrected. Repairs to this telephone equipment can only be made by the manufacturer or its authorized agents or by others who may be authorized by the FCC. For repair procedures, follow the instructions outlined under the VTECH Limited Warranty.
The REN is useful in determining the number of devices you may connect to your telephone line and still enable the devices to ring when you receive a call. The general rule is that the REN value should not exceed 5.0 total; however, contact your local telephone company for the specific number in your area.
IC (Industry Canada)
This telephone is registered for use in Canada.
Notice: The Industry Canada label identifies certified equipment. This certification means that the equipment meets certain telecommunications network, protective, operational and safety requirements. Industry Canada does not guarantee the equipment will operate to the user’s satisfaction.
Before installing this equipment, users should ensure that it is permissible to be connected to the facilities of the local telecommunications company. The equipment must also be installed using anacceptable method of connections. The customer should be aware that compliance with the above conditions may not prevent degradation of service in some situations.
Repairs to certified equipment should be made by an authorized Canadian maintenance facility designated by the supplier. Any repairs or alterations made by the user to this equipment, or equipment malfunctions, may give the telecommunications company cause to
Users should ensure for their own protection that the electrical ground connections of the power utility, telephone lines and internal metallic water pipe system, if present, are connected together. This precaution may be particularly important in rural areas.
Caution: Users should not attempt to make such connections themselves, but should contact appropriate electric inspection authority, or electrician, as appropriate.
The Load Number (LN) assigned to this device denotes the percentage of the total load to be connected to a telephone loop which is used by the device to prevent overloading. The termination on a loop may consist of any combination of devices subject only to the requirement that the total of the load numbers of all devices does not exceed 100.
This device complies with
This equipment may not be used on coin service lines provided by the phone company or on party lines.
request the user to disconnect the equipment.
22
21