VTech SP1733 owner manual Wall Mounting, Using the Wall Mount Adaptor

Page 15

WALL MOUNTING

USING THE WALL MOUNT ADAPTOR

1.Position the wall mount bracket on the Base Unit.

Line up the tabs on the wall mount adaptor with the holes on the bottom of the Base Unit . Snap the wall mount bracket firmly in place.

2.Mount the Base Unit on the wall. Position the Base Unit so the mounting studs will fit into the holes on the bottom of the Base Unit. Position the power cord to extend down the wall the phone is to be mounted on. Slide the Base Unit down on the mounting studs until it locks into place.

3.Plug in the AC adaptor.

Plug the AC adaptor into an electrical outlet, and the DC connector to the back of the Base Unit. If the Handset battery pack has not been charged

previously, place the Handset in the Base Unit cradle, and allow it

to charge for 16 hours.

4.Connect the telephone line cord. The telephone line cord has a snap-in plug at each end. Insert one of the plugs into the jack on the bottom of the Base Unit. Insert the other end of the plug into the wall jack.

1 2

Image 15

Contents Page Table of Contents O N E B O O K SET Time Clear ALL Memory Auto Answer ON/OFFIntroduction Special Features Parts Checklist Sprint National Help Desk at FCC and IC RegulationsFCC and IC Regulations IC Industry Canada Important Safety Instructions Important Safety Instructions Word about RECHARGE- Able Batteries Installing the Battery PackTo Charge the Battery Pack IT’S Impossible to OVER- Charge the Battery PackSpare Battery Charger / Power Backup Function Replacing the Handset Battery PackGetting Started Wall Mounting Using the Wall Mount AdaptorHandset Layout Base Layout Making Calls Setting TimeQuick Reference Guide SET-UPRinger Control Volume ControlAnswering Calls Temporary ToneHold Redial with the Handset on OFF HookMute From the Handset Redial with the Handset OFF on Hook PAGE/HANDSET LocatorIntercom Between Handset and Base Speakerphone on Speakerphone OFFConference Reviewing Caller ID RecordsMemory Dialing Flash RDL Redial Softmenu FunctionsMenu MEM MemoryThird screen is Save Caller IDPhone DialCaller ID Call Waiting ID Editing Phone Book Records Phone BookXX location displayed is its origi- nal location Adding NEW Phone Book RecordsPress Save to confirm your loca Ringer Tone / Volume KEY Beep ON/OFF SET Time Clear ALL MEM AUTOANSWERON/OFF SET Tone /PULSE Headset Operation OperationBelt Clip OUT of Range Indication Additional Operating TipsRepeat Dialing Custom PAY-PER-USE PPU FeaturesCheck AC Power Indication LOW Battery IndicationMaintenance Phone DOESN’T Work AT ALL Handset does not Ring When YOU Receive a CallYOU Hear Other Calls While Using Your Phone Case of DifficultyLimited Warranty Warranty StatementTechnical Specifications Issue