PHONE SETUP:
Slots for the wall mount and phone stand
Installing the phone (Wall Mount):
1.Attach the wall mount to the slot on the back of the phone.
2.Attach the phone to the wall via the wall mount hole
3.Pull out the tab on from the handset cradle. (See figure below)
4.Rotate the tab and plug it back into the slot with the extension up to hold the headset while the phone is mounted on the wall. (See figure below)
Handset Rest |
Tab with extension up |
Tab with extension down
Installing the phone (Phone Stand) :
For installing the phone on the table with the phone stand, attach the phone stand to the bottom of the phone where there is a slot for the phone stand.
CONNECTING THE PHONE:
Refer to the illustration below when following the setup instructions .
PC Port |
|
|
| Handset Port |
|
|
LAN Port | Power Headset Port |
To setup the GXP2100, follow the steps below:
1.Connect the handset and main phone case with the phone cord.
2.Connect the LAN port of the phone to the
3.Connect the 5V DC output plug to the power jack on the phone; plug the power adapterinto an electrical outlet.
4.The LCD will display provisioning or firmware upgrade information. Before continuing, please wait for the date/time display to show up.
5.Using the phone embedded web server or keypad configuration menu, you can further configure the phone using either a static IP or DHCP.
3 | 4 |