Converting a New Phone from Sccp to SIP

Chapter 2 Preparing to Install the Cisco Unified IP Phone on Your Network

Using Cisco Unified IP Phones with Different Protocols

•Adding Phones with Cisco Unified Communications Manager Administration, page 2-17

Using Cisco Unified IP Phones with Different Protocols

The Cisco Unified IP Phone can operate with SCCP (Skinny Client Control Protocol) or SIP (Session Initiation Protocol). You can convert a phone that is using one protocol for use with the other protocol.

This section includes these topics:

•Converting a New Phone from SCCP to SIP, page 2-18

•Converting an In-Use Phone from SCCP to SIP, page 2-19

•Converting an In-Use Phone from SIP to SCCP, page 2-19

•Deploying a Phone in an SCCP and SIP Environment, page 2-20

A new, unused phone is set for SCCP by default. To convert this phone to SIP, perform these steps:

Procedure

Step 1 Take one of these actions:

•To auto-register the phone, set the Auto Registration Phone Protocol parameter in Cisco Unified Communications Manager Administration to SIP.

•To provision the phone using the Bulk Administration Tool (BAT), choose the appropriate phone model and choose SIP from the BAT.

•To provision the phone manually, make the appropriate changes for SIP on the Phone Configuration page in Cisco Unified Communications Manager Administration.

	Cisco Unified IP Phone 7961G/7961G-GE and 7941G/7941G-GE for Cisco Unified Communications Manager 6.0
2-18	OL-11953-01